|
|
|
Related Items
SIMU Roll Shutter Tubular Motor Kit, Standard or With Override, Type 6, 4 wire
100Nm, 14 rpm, 120V, 60Hz, 430W, 3.8A, 4min, IP44, 22, 308-448lbs
Kits include the 70MM Crown, Drive, and Motor Bracket.
STANDARD: #510SK, 27.125" Long, 2 Brackets
OVERRIDE: #529SK, 26.25" Long, 1 Bracket
** Note about Buying a Tubular Motor from us; All our Manual Override type motors, use a HEX SHAFT for the Motor Gear connection to the Universal Pivot, if you have a Square Shaft you'll need to replace the Universal Pivot or use our Square to Hex Coupling Adaptor.
Other smaller size SIMU T6 Override Motors available by Special Order! They are not kits it is Just The Motor, Please Call To Order, wait is possible 1-2 weeks.
Standard w/Override Motor
660-2000985 = 60Nm, 14rpm, 60mm, 120V, 60Hz, 285W, 2.5A, IP44, 185 - 268 lbs
680-2000986 = 80Nm, 14rpm, 60mm, 120V, 60Hz, 390W, 3.4A, IP44, 246 - 358 lbs
** Lifting Capacity decreases as the height increases.
Please call Customer service at 561-255-1102 for help ordering the correct SIMU motor.... Please have your Make & model number handy, and know what size tube or sleeve you have (58mm Hex, 60mm/70mm Round/Hex, 94mm, 100mm).
**Note about installing Tubular Motors;
If you are testing a tubular motor for electrical current or trying to set the limit switch, you must do it in the tube (or a test tube) as the Crown & Drive Must Spin Together, or the motor will not reset itself, or the motor may not shut off, or the limit switch will not stay in the same position!!!!!
